Woder 10K Gen3 Review – All That You Need To Know


Woder 10K is the best pick for you in a budget segment which ensures you the best healthy quality drinking water in your home.

The product is NSF certified, but kindly keep this in mind that this product is only suitable in filtering the municipal cold water, so any salt, soft, hard water won’t be able to get the job done. Also, it won’t work on hot and well water.

This device isn’t compatible with hot water like other devices that you see in the market, which filters down hot water. However, the product still stands up to be a value for money product and offers you healthy and quality drinking water. The product is enduring and has a long lifespan.


Woder 10K-Gen3 Ultra High Capacity Direct Connect Water Filtration System

The microparticles of this filter many ingredients related to an ordinary filter. So this gives this system a vast capacity to purify the water, and the device keeps functioning for 3 years.

The device removes all the essential things that shouldn’t be in your water. The filter gets rid of almost 99.9% of the lead, chlorine, heavy metals, chemical substances, mercury, chromium, carcinogens, foul odor, and bad taste. So getting rid of all these things is what it takes to have clean, healthy drinking water.

In RO systems, you might have seen that they taste a little mineral at the start. But that’s not the case in this device. It keeps the essential minerals in the water to provide you a pleasant experience.

The flow of the device will be constant and will not be gradually decreased. The flow rate is 2 GPM, and the maximum pressure of the flow is 125 PSI. The temperature which is advisable for this device is from 43 to 100 degrees.

The product comes with a 1 year replacement warranty and can give up to 10000 gallons of water for the next 3 years.


Non-BPA or vinyl chloride plastic is used to make this device. It weighs around 2.9 pounds and is about 3 x 3 x 15 inches in size.

The product is a fully ready installation set. Comes with a built in valve, filter, an inlet hose(3/8 inch female compression by ¼ inch pipe thread) and an outlet hose(3/8m compression by ¼ standard pipe).

Installation and maintenance

The installation process is straightforward and simple, and should not take more than 10 minutes of your time. The cold water line should be directly connected to the product so that you don’t need to add another faucet. The size of the product should be able to fit under your kitchen sinks. But after 3 years when it’s time to change the product you’ll have to remove the whole thing.


• The whole system and its part is NSF certified.

• Is an efficient product in a budget segment.

• Easily maintained and installed.

• Doesn’t eliminate the essentials minerals of your water.


• The water pressure might not meet your expectations.

• The device isn’t compatible for well, salt, soft water.


Related Articles –

Culligan WH-HD200-C Review – All That You Need To Know

APEC WFS-1000 Review – All You Need To Know About It

Home Master HMF3SDGFEC Review – All That You Need To Know

Like it? Share with your friends!